VIKING GARDEN MT 4097 S, Instruction Manual

Page: 41 / 306

EN
NO
39
SV
FI
DA
PL
0478 192 9804 B - EN
Rear wheels:
Insert the feather key (6) in the rear wheel
axle. Fit the wheel (5) – valve located on
outside – over the feather key and push
onto the wheel axle to the stop.
Push the small washer (4) and the large
washer (3) onto the wheel axle.
Front wheels:
Fit the wheel (5) – valve located on outside
– onto the wheel axle to the stop.
Push the large washer (3) onto the wheel
axle.
Allow the retaining ring (2) to engage in the
groove on the wheel axle.
Fit the cap (1) onto the wheel axle.
● Lift the machine and pull out the
support.
● Carefully set the machine onto the
ground.
14.11 Lubrication
Lubricate the two front steering knuckles
via the two grease nipples on the front
axle.
Lubricating:
● Stop the engine. ( Ö 12.3)
● Remove the ignition key and keep it in a
safe place.
● Engage the parking brake. ( Ö 8.12)
● Unload the front axle by supporting
(lifting) it. (
Ö 14.10)
Using a grease gun (not included in
standard equipment), inject grease on
both sides via grease nipples (1) until
small amounts of grease escape from the
steering knuckles.
● Remove escaping lubricating grease.
● Remove support for the front axle.
14.12 Checking the engine oil filling
level
● Park the machine on a flat, level
surface.
● Stop the engine. ( Ö 12.3)
● Engage the parking brake. ( Ö 8.12)
● Allow the engine to cool down.
● Open the engine hood. ( Ö 14.3)
● Check the filling level as per the engine
instruction manual – top up the engine
oil if necessary. (
Ö 14.13)
Check that the wheel is seated
securely.
Note
Before lubricating, the front axle
must be unloaded by supporting
appropriately.
The grease nipple must be cleaned
before lubricating, so that no dirt
enters the steering knuckle.
Escaping grease should always be
removed (wiped off) after
lubricating.
Use commercially available
lubricating grease.