0478 131 9937 B - EN
152
●
Tilt the robotic mower onto its side and
lean it securely against a stable wall.
Carefully clean the mowing deck and
mowing blade. (
Removing the mowing blade:
Push in both tabs (1) on the
carrier plate with one hand and
hold. Remove the fastening
nut (2) with your other hand.
Remove the mowing blade together with
the fastening nut.
Installing the mowing blade:
●
Clean the blade, carrier plate and
fastening nut prior to installation.
Fit the mowing blade (1) on the carrier
plate (2) as illustrated. Ensure the correct
position of the retainers (3) in the mowing
blade.
Screw on the fastening nut (1) as far as
possible. Several clicks are audible during
tightening. Ensure secure seating of the
mowing blade by shaking carefully.
●
Following installation of a new mowing
blade, confirm the blade replacement in
the "Service" menu. (
16.5 Sharpening the mowing blade
Never
resharpen blades.
VIKING recommends
always
replacing a
blunt blade with a new one.
16.6 Removing and installing the
carrier plate
●
Activate the disabling
device (
gloves.
●
Tilt the robotic mower onto its
side and lean it securely against a
stable wall. Carefully clean the mowing
deck and mowing blade. (
Removing the carrier plate:
●
Risk of injury!
Check the blade for damage before
installing. The blade must be
replaced if notches or cracks are
detected or if it is worn. (
The
carrier plate
and the
fastening nut
must also be
replaced if damaged (e.g. broken,
worn). The fastening nut in
particular must engage cleanly in
the carrier plate.
Only new mowing blades are
balanced with the necessary
precision and guarantee proper
functioning of the machine as well
as low noise emissions.
The carrier plate can be removed in
order to clean the mowing deck.
