Vigitron MaxiiNet Vi30018, Operational Manual

Page: 58 / 122

Page | 58
Caution: Do add a tag to the port used to configure the switch and in
some cases the NIC will not recognize 802.1Q
Don’t Care: The outgoing packet of the selected port will the original
packet format of the source port.
Remove Tag: If the outgoing packet of the selected port receives a packet
with a 802.1Q tag it will be removed. No other changes will be made to
the packet
Update: After all the selections are made select Update to apply.
Caution: If the port you are using to monitor is not programmed at Rx/Tx
or not selected as part of the VLAN, you will lose your connection to the
switch and have to return to the default settings.
NOTE: In tag based VLAN mode, adding tag on the port which
is used to configure this switch is not allowed, because some
NICs cannot recognize 802.1Q tag.
Example:
Port 1: The 802.1Q tag of every packet outgoing from this port
will be removed.
Port 4: The 802.1Q tag of every packet outgoing from this port
should be included.
Other ports: keep every outgoing packet intact.
12.1 VLAN
Member (Port
Based)
This setting is designed based on the VLAN member of each port. The
following examples illustrate how to configure VLAN in this mode.
The Table is configuring the port-based VLAN member of each port.
When the port received the packets allows only forwarded to the VLAN
member of this port. The function for each button shown on this page is
expressed below.