Vigilantplant TDLS8000, User Manual

Page: 135 / 320

<6. Configuration>
6-20
IM 11Y01D01-01EN
Item name
(HART)
Initialization target
Setting data
All parameters settable from YH8000 and HART
(All parameters in section 6.11.2 except for “User info.”)
AI/AO cal data Input/output calibration data of AI/AO
Calibration data Zero/span calibration data
User info
TDLS8000 tag, IP settings, HMI (YH8000) user password, HART address,
HART 8-character short tag, write protect password
NOTE
When initialization is executed, the TDLS8000 restarts automatically.
6.11.2 Parameter Initial Value List
The initial values of parameters at the time of shipment are as follows.
Parameters with ○ in the “User specification” column are initialized to the values specified by the
customer at the time of ordering if the values were specified by the customer at that time.
l
Process parameters
Parameter Initial value User
specification
Min. – Max.
OPL (Optical Path Length) 0.660[m] ○ 0.01 – 100[m]
Pressure mode Active input Select in the screen
Pressure value for fixed mode 101.325[kPa] 0.1 – 10,000[kPa]
Pressure active input source AI-1 Select in the screen
Pressure value at 4mA 40[kPa] 0 – 10,000[kPa]
Pressure value at 20mA 200[kPa] 0 – 10,000[kPa]
Pressure backup mode when AI-1 input is out of range or under AI
calibration
Backup value Select in the screen
Pressure backup set value 101.325[kPa] 0.1 – 10,000[kPa]
Temperature mode Active input Select in the screen
Temperature value for fixed mode 25[deg C] -273 – 3,000[deg C]
Temperature active input source AI-2 Select in the screen
Temperature value at 4mA input 0[deg C] -273 – 3,000[deg C]
Temperature value at 20mA input 100[deg C] -273 – 3,000[deg C]
Temperature backup mode when AI-2 input is out of range or
under AI calibration
Backup value Select in the screen
Temperature backup set value 25[deg C] -273 – 3,000[deg C]
Temperature offset for active ambient method -6[deg C] -100 – 100[deg C]
l
Non-process parameters
Parameter Initial value Min. – Max.
Non-process OPL 0[m] 0 – 10[m]
Non-process pressure 101.325[kPa] 0.1 – 10,000[kPa]
Non-process temperature mode Fixed Select in the screen
Non-process temperature 25[deg C] -273 – 3,000 [deg C]
Non-process temperature compensation coefficient for active
ambient method
0.5 0 – 1
Non-process concentration for measurement gas 1 0[ppm] 0 – 1E6[ppm]
Non-process concentration for measurement gas 2 0[ppm] 0 – 1E6[ppm]
3rd Edition: Jun. 10, 2016-00