Vigilantplant TDLS8000, User Manual

Page: 134 / 320

<6. Configuration>
6-19
IM 11Y01D01-01EN
Table 6.6 Insertion tube length
Part name E, E’ (mm)
Insertion tube
Insertion tube length including flange part
(Depends on measurement application)
l
Non-process optical path length of TDLS8000
Convert the LU section SCU section length [mm] to the unit set for the optical path length
and set the result as the non-process optical path length.
6.10.2 Non-process Pressure Setting
Set the pressure value of the non-process area.
Setup menu path:
[HART] “Detailed setup>>Analysis>>Non process param>>No-prcs pres”
[YH8000] “Configuration>>Analysis>>Non-Process Parameters>>Pressure”
6.10.3 Non-process Temperature Setting
Set the temperature input mode of the non-process area. Also, set the fixed temperature value
when the mode is fixed and offset value when the mode is “Active ambient.”
Setup menu path:
[HART] “Detailed setup>>Analysis>>Non process param>>No-prcs temp”
[YH8000] “Configuration>>Analysis>>Non-Process Parameters>>Temperature”
6.10.4 Non-process Concentration Setting
Set the concentration of the gas to be measured that is included in the non-process area.
Setup menu path:
[HART] “Detailed setup>>Analysis>>Non process param>>No-prcs conc”
[YH8000] “Configuration>>Analysis>>Non-Process Parameters>>Concentration”
6.11 Initializing the Settings (Factory Default
Settings)
This section describes the procedure to restore the settings to the state at the time of shipment
and lists the initial values of the parameters at the time of shipment.
6.11.1 Initialization Procedure
Execution menu path:
[HART] “Detailed setup>>System>>Initialize config”
[YH8000] >>Configuration>>System>>Configuration Initialization"
To execute initialization, open the above menu and then select from the following depending on
the types of parameters you wish to initialize. Multiple items can be selected at the same time.
3rd Edition: Jun. 10, 2016-00