Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
10-8
This section sets out the LCD messages that may be encountered during
service operations. The messages are listed in alphabetical order.
Due to ongoing changes to system software (firmware), these lists are
subject to change without prior notice.
LCD Messages
Message
Occurs In
Meaning
Invalid
Logon Display
User code and/or password
entered do not match that
contained in the active
datafile.
Next is OLDEST
History recall
User has pressed the ‘next’
button to view a newer history
event, however there is none.
The menu therefore wraps
round and displays the oldest
history event.
No History to View
History recall
There is no stored history.
No offnormal zones
found
Zone recall
There are no off-normal
zones.
No offnormal points
found
Point recall
There are no off-normal
points.
Zones not found
Zone recall
There are no zones set up as
“Show in Sequential Recall”.
No faults found
Fault recall
There are no zones or points
in fault.
No disables found
Disables recall
There are no zones or points
disabled.
No TESTS in progress
No Tests Found
Tests recall
There are no zones or points
currently under test.
Previous is NEWEST
User has pressed the
‘previous’ button to view an
older history event, however
there is none.
The menu therefore wraps
round to display the newest
history event.
Test cannot start at
this time.
Point Test Screen
–
performing operate, alarm test
normal, alarm test fast.
Point is not configured to
perform the test requested.
This point cannot be
disabled
Point disable display, Point
Test Screen, Point Recall
Screen.
Configuration does not permit
this point to be disabled by
operator.
This zone cannot be
disabled
Zone isolate display, Zone
Test Screen, Zone Recall
Screen.
Configuration does not permit
this zone to be disabled by
operator.
Wrapping to first in
list
Recall screens
The next item is the first in the
list.
Quick Reference
– Alphabetical List of Possible LCD Messages
