53
Installing the dust filter (optional accessory)
Caution
• It is important to clean the dust filter every 100 hours after the dust filter is installed.
• Be sure to turn off the projector and unplug it from power source before installing or
detaching the filter.
• If your projector is ceiling-mounted or is not easily accessible, pay special attention to
your personal safety when replacing the dust filter.
Installing the dust filter
1. Be sure to turn off the projector and unplug it from power source.
2. As the arrows shown to the right, fit the filter by
aligning and inserting it into the projector slots.
Make sure it clicks into place.
For first time installation:
3. Open the OSD menu and go to the
SYSTEM
SETTING: ADVANCED
>
Filter Settings
menu.
4. Press
Enter
and the
Filter Settings
page is
displayed.
5. Highlight
Filter Mode
and select "
On
". The filter timer starts counting and the
projector will remind you to clean the filter when the filter is in use for over 100
hours.
Caution
• Set Filter Mode to On only when using the projector after the dust filter (optional
accessory) is properly attached. Failing to do so will result in a shorter lamp life.
Obtaining the filter hour information
1. Open the OSD menu and go to the
SYSTEM SETTING: ADVANCED
>
Filter
Settings
menu.
2. Press
Enter
and the
Filter Settings
page is displayed.
3. You will see the
Filter Hours
information on the menu.
Cleaning the dust filter
1. Be sure to turn off the projector and unplug it from power source.
2. Press the latches on the dust filter and remove the filter from the projector.
3. Use a small vacuum cleaner or a soft brush to sweep the dust on the filter away.
4. Re-install the dust filter.
Summary of Contents for PJD6250L
Page 80: ...69 IR control table System Code 83F4 Format NEC ...
Page 87: ......
