6
C. Safety Instructions
Read all of these safety instructions before using the embossing printer. In addition, follow all
warnings and instructions marked on the embossing printer itself.
Do not place embossing printer on an unstable surface.
Do not place embossing printer near a radiator or heat source.
Do not block or cover slots and openings in the embossing embosser's
cabinet; do not insert objects through slots.
Use only the type of power source indicated on embossing embosser's
label.
Connect all equipment to properly grounded electrical outlets.
Do not use frayed or damaged power cord.
The use of an extension cord with the embossing printer is not
recommended.
Unplug embosser before cleaning it; always clean it with a piece of damp
cloth only.
Do not spill liquid into embossing printer.
Except as specifically explained in the user's manual, do not attempt to
service the embosser by yourself.
Detach the embosser from power source and refer to qualified service
personnel under the following conditions:
o
If the power cord or plug is damaged.
o
If liquid has entered the embosser.
o
If the embosser has been dropped or the cabinet is damaged.
o
If the embosser does not operate properly or exhibits a distinct
change in performance.
Only adjust those controls that are covered by the operating instructions.
