35
Removing the top cover
In order to make the electrical connection of the heat pump, remove the entire cover
by undoing its screw.
1.
Undo all screws at the bottom of the front panel.
2.
Remove screws from the front panel and put them aside.
3.
Remove the front panel (incl. control unit) and put against the r.h. side of the heat
pump. The maximum length of the connecting cable is 2 m.
4.
Undo the connecting cable to the programming unit only if necessary.
5.
Lift off the top cover.
Installation sequence
Siting the heat pump
5848 449 GB
Installation
