42
!
Please note
If a casing door is not securely closed this can
lead to damage from condensation, vibrations
and excessive noise.
Seal the appliance so it is soundproof and diffu-
sion-proof.
Prior to closing the heat pump, check the following:
■
Are all cables inside the wiring chamber sufficiently
secured (strain relief, cable ties)?
■
Has the programming unit been fitted and connec-
ted?
■
Have all earth conductors been fitted?
■
Have all cable entries been correctly applied and
sealed against moisture ingress?
■
Do all hydraulic connections have airtight sealing
and insulation with thermal and vapour diffusion-
proof materials?
■
Have transport brackets been removed?
■
Are the back and side panels securely attached?
2.
3.
1.
Fig. 23
2.
Carefully position the front panel. Pay particular
attention to the shaft between the dial and the
ON/OFF switch.
4.
Hand over product documentation for service and
Allen key to the qualified contractor.
Installation sequence
Closing the heat pump
(cont.)
5789 986 GB
Installation
