66550033-EN - V6.1 - 15/08/20
- 15 -
ESVK/6388 Series “2 wire Bus” videokit
ESVK/6388 Series - Installation handbook
REPROGRAMMING A MASTER TAGS
If the master tag is lost or damaged, a new one can be programmed using the following procedure:
1. Switch off the power.
2. Open the external module housing.
3. Bridge the
PTE
and
GND
terminals or press and hold down the “press to exit” button, if this
is wired to the external module (refer to the external module's instructions).
ON
1 2 3 4 5 6 7 8
STEEL
MATTE
ALI
HIGH BRASS
4384X-1
4384X-0
4384X-2
EXPANSION
BUTTONS
NC
VAUX
+C
C
NO
GND
PTE
BUS
BUS
+V2
GNDV
VID2
Balance
A
B
GND
RS485
4384-1
4384-0
4384-2
Made in Italy
4. Switch the power back on.
↪
The external module emits a high-pitched
“beeping”
sound.
BIP
5. Remove the short between the
PTE
and
GND
terminals or release the “press to exit” button.
↪
The external module emits a high-pitched
"beeping"
sound.
BIP
6. Place the master tag in front of the tag reader.
↪
The external module emits two high-pitched
“beeping”
sounds, then two low-pitched
“beeping”
sounds, the master tag is programmed, all user tags have been deprogrammed
and the external module exits programming mode.
BIP BIP
BIP BIP
7. Close the external module's housing.
HOW TO REMOVE/INSERT THE CARD NAME HOLDER
• To avoid damage to the module front plate, mask the side that
will be in contact with the screwdriver blade;
• Insert the screwdriver (flat side) into the card-holder hole as
shown in
• Move the screwdriver to the left as shown in
to extract
the card name holder;
• Edit the card name then replace it inside the holder and refit:
insert the holder inside its housing from the left or right side
then push the other side until it clips into place.
Fig. 8
Fig. 9
ADHESIVE GASKET PLACEMENT
Apply the
Y
seal as shown in
ANTI-TAMPERING LOCKS FIXING
Fit the anti-tampering locks
W
as shown in
.
Y
G
Fig. 10
W
Fig. 11
Art. 4384
Speaker unit with built-in camera
Art. 4384X
Speaker unit with built-in camera & proximity key reader