Videotec WASPT, Instruction Manual

Page: 15 / 134

Instruc
tion manual - English - EN
13 MNVCWASPT_2045_EN
6.6.2 Pump with 5m (16ft) delivery
Fill the tank with water and insert it in the metal cage.
Insert the pump in the tank and close the cap.
The system is ready to be powered.
6.6.3 Pump with 11m (36ft) delivery
Adjust the level switch (6.6.1 Adjustment of the level
switch position, page 12).
Fill the tank with water and insert it in the metal cage.
Insert the pump and the level switch in the tank and
close the cap.
The system is ready to be powered.
6.6.4 Pump with 30m (98ft) delivery
Avoid contact with the pump delivery hose
coupling. Hot surfaces may cause personal
injury if touched.
Adjust the level switch (6.6.1 Adjustment of the level
switch position, page 12).
Fill the tank with water and insert it in the metal cage.
Ensure that the male/female hydraulic joint (01) is
inserted correctly. Insert the level switch in the tank
and close the cap. Check the delivery hose coupling
for the pump (02) to make sure a small quantity of
water comes out.
02
01
Fig. 13
Unscrew the knurled nut (01) from the delivery joint
(02). Insert the knurled nut on the delivery pipe (03).
Insert the end of the delivery pipe into the spinner
(04). Lock the nut to the coupling.
02
01
03
04
Fig. 14
At the end of the installation operations, re-assemble
the casing working in the reserve order (5.3 Opening
of the 30m delivery head pump casing, page 6).
Pay attention to the fixing. Tightening
torque: 7Nm.
The system is ready to be powered.