Videotec DCZ, Instruction Manual

Page: 17 / 84

EN - English - I
nstruc
tions manual
15
Changing lookup values enables you to:
• Have more keys which are acknowledged as the
same key;
• Change the default position and the number of
joystick keys in JOYHID mode.
9.7.1 Lookup value index
The lookup values range from 0.to 65535.
Certain value intervals have a special meaning:
• 0: Disabled key;
• 1..99: Normal key, the value is sent when the key is
pressed and released;
• 1001..1008: Shift Key descriptions;
• 50011..50089: Definition of multiple keys;
• 60001..60032: Assigning of keys in JOYHID mode;
• 60101..60103: For internal use, not available.
If a value of
01
-
99
is set, the corresponding code will
be sent by the keyboard when the key is pressed/
released in VCOM mode.
By setting a value between 1001-1008, the key
becomes a shift key. If any key is pressed while one
or more shift keys are pressed the message [
K+ xx
]
changes to [
K+ xx:pressed_shift_list
].
More than one shift key can be contemporaneously
pressed at any time.
If a value of
500 rc
(
rc
within the range of 11..89) is
set, this creates an alias and links the behaviour of the
key to another
rc
. logical coordinate key. This allows
you to manage a number of keys with the same
behaviour as if they were one single key.
If a value of
600 nn
(
nn
in the range of 01-32) is set,
the key will be assigned to the corresponding joystick
key
nn
in JOYHID mode.
9.7.2 Modifications to the lookup chart
to move and change the number of
joystick keys.
Modification to the lookup chart allows you to
change the position or the number of joystick keys
when in JOYHID mode.
9.6 LED updates
The effect of the [
Led+ xx
], [
Led- xx
] abe [
Led/ xx
]
commands is usually immediate.
If it is necessary to set a number of LEDs at the same
time, there may be an update delay mainly due to the
asynchronous communication between the keyboard
and the PC.
A temporary buffer is used to avoid a delay of this
kind: after setting the temporary buffer values,
an update operation is performed so that the
contemporary change of all the modified LEDs is
visible.
The following commands are used to this purpose:
COMMAND MEANING
[LedImmediate]
The update of the LED is immediate
[LedDelayed]
The update of the LEDs is delayed
until the first command is received
[LedUpdate]
.
In the meantime, all the
[Led+ xx ]
,
[Led- xx ]
and
[Led/ xx ]
commands are memorized in a
temporary buffer.
[LedUpdate]
The temporary buffer is copied
to the active buffer and all the
modification made in the meantime
are now visible
[LedCopy]
The active buffer copies back to the
temporary buffer
Tab. 04
9.7 Lookup chart (for experts
only)
Each key is assigned a value found on the key
lookup. The default value corresponds to the logical
coordinates of the key (for instance, the
ESC key row
1, column 3, corresponds to a value of 13).
The
LookupWrite
command allows you to modify
the value assigned to a key.
g h
The changing of lookup values can cause
apparent system malfunctions in the event
that it is necessary to replace the keyboard
at a later date. It is highly recommended to
document any modifications made.