A
150
Digital Recorder
20
9.4 Configuration
9.4.1 User
Password
If you wish to set a password, enter a six digit number here. Enter all zeros to remove the
password.
When a password has been set, access to the menu will be prohibited until the user “logs
on” by pressing the PSW key and entering the correct password.
If you set a password, be very careful to make sure that it is recorded, otherwise access to
the menus will not be possible again.
9.4.2 Camera
Inputs
9.4.2.1 Record
Brightness
The brightness of the images being recorded can be adjusted to compensate for cable
losses. Adjust the brightness as required for each camera.
•
If the displayed image (which is digitised) is too dim or is tearing,
increase
the
brightness setting.
•
If an image is too bright,
decrease
the brightness setting.
9.4.2.2
Record Colour Boost
The colour content of the images being recorded can be adjusted here to compensate for
cable losses. Adjust so that the colour content of the displayed image is not too weak or too
strong.
9.4.3
Restore Factory Config
Press the
YES
key to restore the configuration to the factory defaults.
9.4.4
Erase Hard Drive
Press the
YES
key to erase the hard drive.
9.4.5 Unit
Address
This address need only be changed if more than one Ai150 is to be controlled from one
remote keyboard.
In this case, give each Ai150 a different unit address. For example “001”, “002”, “003” etc.
