22
Captivator Pro & Captivator ProTV User Guide
Setup displays details of any device that occupies each of the
base addresses scanned, and chooses a base address and
interrupt setting that is suitable for your Captivator Pro/TV.
Although very reliable, the Scan option is not 100% accurate
as the configuration of your computer is not designed to be
read using software. This is particularly true of interrupts that
are used by device drivers that run under Windows—these
interrupts are only used intermittently, and so are very
difficult to detect.
6. Accept the setting or choose another base address or interrupt
from the available options, then choose OK.
If you have changed the original interrupt setting, restart
Windows so that your change can take effect.
If you have changed the base address, follow step 7 below.
7. Exit Windows. Switch off your computer, monitor, and any
hardware devices such as printers connected to your
computer. Leave the power cable connected to the power
outlet so that your computer is grounded.
Warning: Always switch off your computer before removing the
cover and observe the warnings specified in the manufacturer’s
documentation.
Remove the computer’s cover. Refer to the documentation
supplied with your computer if you are not sure how to do
this. Discharge any electrostatic charge that may have built up
on you or your clothes by touching the metal frame of your
computer—see Handling Captivator Pro/TV on page 10.
Reposition the jumper as necessary. The base address settings
are printed on the card. If you have to take the card out of its
expansion slot to reposition the jumper, carefully disconnect
the VM-Channel cable from Captivator Pro/TV. When you
have repositioned the jumper, reinstall your card following
the instructions on pages 15–18.