Videocon MS901K-AP, Service Manual, Page: 24 / 43

Factory Test & Alignment Specification For MS801-AP Series (V1.0)
Page 15 of 17
USB
Clone
USB Clone Mode All
Select to choose the things you want to
clone
TV TO USB Do
Press “
Right
” key
to copy the data(WB,
ADC, picture setting, etc) to USB
USB TO TV Do
Press “
Right
” key
to set the data(WB,
ADC, picture setting) from USB
9-Preset Factory Channel submenu
Item Sub-item Value Note
Preset
Factory
Channel
Factory Area
HuiZhou/
WuXi/
NeiMeng/
SuZhou
Preset the channel table of factory. Press
“
Right
”
or
“
Left
”
to choose the
corresponding factory name.
Channel Preset Do
Press
“
Right
”
or
“
Left
”
to preset the
channel that has be chosen
Appendix
 “
Instructions of Updating Device ID, User ID and MAC address
”
1, Use the UART command to sent Device ID and MAC address using the command:
Device ID write: B2 DATA 0 TO DATA N(ASCII )
User ID write:B8 DATA 0 TO DATA N(ASCII )
MAC address write:B3 MAC address 6
（
Binary
）
The process is as the picture below:
Portal give the User ID and Device ID to the factory local service, and the service connect to the factory LAN.
When product line produce the IPTV , there will be a work station (PC normally) down load the Device ID ,
User ID and also MAC address from the local service ,then using UART command sent them to the module.
2,How to test the function:
When there is a module need to test the Device function connect the set to the LAN use the device ID test the
module will sent the device ID information and user ID information to the local service and compare with the