Videocon MS901K-AP, Service Manual, Page: 15 / 43

Factory Test & Alignment Specification For MS801-AP Series (V1.0)
Page 6 of 17
Signal:
VGA: 5 MOSAIC YPBPR: 100% Color Bar
5 MOSAIC
100% Color Bar
See Appendix

“Factory Menu Description”
1.6. DDC & EDID Test
It
’
s necessary to check whether the correct EDID is downloaded.
1.7. HDCP Test
For HDCP compliancy,
it’s needed to check w
hether the HDCP key has been well set. The
starting address of HDCP KEY in U402 (Mboot) is 0x1C0015.
1.8. LAN/WLAN Test (MAC address and Device/User ID codes)

MAC Address Upgrade
See Appendix
 “How to upgrade
MAC Address”

Device ID (DID) and User ID (UID)
Purpose is to allow Other Network Download (OND) and further specific services over dedicated
portal based on AP.
Description/Portal Links/Flow chart are welcomed?
For such, specific Device ID (32 bytes) and User ID (8 bytes) needs to be paired and overwritten
into memory for internal client encryption.
Here are below codes examples:
Device ID User ID
BE4F255BBD106BC8F806AE456350D91F 3546187
Those Device ID/User ID codes can only be set using UART commands following enclosed
SIACP requirements (rev. v3.9).
See Appendix

“Instructions of Updating Device ID, User ID and MAC Address”

LAN Test
A rough LAN test can be done by connecting ethernet
to TV’s RJ45 and check
that IP, subnet
mask, DNS addresses,
…
are visible
on “
System Settings

Network Settings

Wired
settings

Auto Get IP Address
” (ensure that “Internet Connection” is Enabled at first).
More