series of images upon detection of
movement.
Disarm – Deactivates the MemoCam unit.
When disarmed, snapshots can be taken
manually using the remote control unit.
Function – Reserved for future
enhancements.
Rec – Triggers a snapshot to be stored in
the Multimedia Card.
Digit buttons numbered 1, 2, 3, and 4 –
Allows for Arm and Disarm Code entry.
Remote control signals can be detected only
from the front of the MemoCam unit.
Insert the two included AAA batteries into the
remote control unit before use.
Arming MemoCam
®
To activate (arm) MemoCam:
1. Verify that the MemoCam unit is powered
and the Multimedia Card is inserted into the
unit.
2. Point the remote control at the unit and
press
Arm (refer to Figure 7 on page 11).
MemoCam emits one long beep and the
Arm mode LED illuminates orange (refer to
Figure 2 on page 6).
The system is preset so that no code is
necessary to arm the MemoCam unit. However,
you do have the option of selecting an arm
code. For information about defining an arm
code, refer to the MemoCam Software Manual.
12
¡
