3. Features
a.
Bluetooth setup and monitoring (Using VictronConnect)
Equipped with integrated Bluetooth; enabling quick and simple setup, advanced configuration, comprehensive monitoring and
firmware updates via the
VictronConnect
app and a Bluetooth enabled device (such as a mobile phone or tablet).
b.
VE.Smart Network compatible
VE.Smart Networking capability allows multiple chargers to operate in unison with synchronised charging, and receive
accurate battery voltage (Voltsense), charge current (Current-sense) and battery temperature (Temp-sense) data from a
compatible battery monitor (such as a BMV, SmartShunt, Smart Battery Sense or VE.Bus Smart Dongle) to further enhance
the charge cycle.
c.
VE.Direct interface
Fully integrate with a
GX device
(such as a Cerbo GX) via VE.Direct interface, enabling system monitoring and control from a
single device and connectivity to the
VRM
(Victron Remote Monitoring) portal for data logging and remote access to real time
monitoring, as well as control of the charger.
d.
Integrated charge presets
Integrated charge presets (selected via the MODE button or VictronConnect app) combined with adaptive charge logic are
well suited for most common battery types; such as LiFePO4, AGM, Gel and flooded lead-acid. Advanced configuration with
specific user defined settings is also possible using VictronConnect.
e.
Multi-stage charge algorithm
The multi-stage charge algorithm is specifically engineered to optimise each recharge cycle and charge maintenance over
extended periods.
f.
Adaptive absorption
Adaptive absorption monitors the battery’s response during initial charging and intelligently determines the appropriate
absorption duration for each individual charge cycle. This ensures that the battery is fully recharged regardless of the
discharge level or capacity and avoids excessive time at the elevated absorption voltage (that can accelerate battery aging).
g.
Temperature compensation
Charge voltage is automatically compensated depending on the ambient temperature; this ensures that the battery is charged
at the optimal charge voltage regardless of the climate and avoids the need for manual settings adjustments. Temperature
compensation is not required and automatically disabled when in LI-ION charge mode.
h.
High efficiency
The
Phoenix Smart IP43 Charger
range is up to ~96% efficient; resulting in lower power usage, less heat generated and
cooler operation
i.
Durable and safe
i.
Engineered to provide years of trouble-free and dependable operation in all usage conditions
ii. Protection against overheating: output current will be reduced if the charger temperature increases above 40°C (linear
derate from 100% at 40°C to 20% at 60°C)
iii. Protection against output short circuit
iv. Protection against reverse polarity connection (internal fuse - not replaceable)
j.
Silent operation
Totally silent operation since there is no cooling fan or moving parts, cooling is via natural convection; full rated output current
is still provided up to an ambient temperature of 40°C.
k.
Lithium Ion compatible
Compatible with Li-ion (LiFePO
₄
) batteries; when the integrated LI-ION charge mode is selected the charge cycle settings are
altered to suit.
If the charger is connected to a battery where under voltage protection (UVP) has tripped, the
Phoenix Smart IP43 Charger
range will automatically reset UVP and start charging; many other chargers will not recognise a battery in this state.
Warning: Do not charge Li-ion batteries if the battery temperature is below 0°C.
l.
Storage stage
An additional stage to extend battery life whilst the battery is unused and on continuous charge.
m.
Recondition stage
An optional stage that can partially recover/reverse lead acid battery degradation due to sulfation; typically caused by
inadequate charging or if the battery is left in a deeply discharged state.
Phoenix Smart IP43 Charger
Page 4
Features
