2. Installation
2.1. What's in the box?
• GlobalLink 520
• 1.5m power cable with 1A inline fuse and M10 eyelets and power connector
• 2 pluggable terminal blocks
What's not in the box
• VE.Direct cables
2.2. Assembly instructions
1. Make note of the VRM Portal ID denoted on the sticker on the GlobalLink 520.
2. Mount the GlobalLink 520 close to the device you wish to monitor.
3. Connect VE.Direct cables between your devices and the GlobalLink 520.
4. Connect the DC Power (8V - 70V).
5. The LED will start blinking blue while it is trying to connect to the network (this could take up to 5 minutes).
6. The LED will blink green and yellow when one VE.Direct device is connected, or only green when two VE.Direct devices are
connected.
7. Visit to the
to 'add' your installation to your account using the Portal ID you wrote down in step 1. You can only
add your device to VRM once it has connected to the network (blinking yellow and/or green).
GlobalLink 520
Page 2
Installation
