Victoria VITTORIA 8, Instruction Manual

Page: 9 / 24

03.2021 INSTRUCTION MANUAL for installation and operation of pellet stove VITTORIA 8
9
Picture.3. Picture.3.1
А -Insulated metal chimney.
В - minimum height of the vertical section 1.5 m, as the end of the chimney has to be completed in accordance with Picture. 3.1
С - Incoming outside air through the section with minimum cross section of 80 сm
2
.
Е -Incoming outside air through the section with minimum cross section of 80 сm
2
.
D -Metal pipe in masonry chimney.
10.Appliance operation.
10.1.
Initial ignition
.
The installer of the pellet stove should perform the initial release!
The installer is obligated to:
- to check the dimensions of the connecting flue pipes and chimney;
- to set the pellet stove according to the type of wood pellets used;
- to carry out emission control of flue gases after installation;
- to make a detailed instruction of the user.
Pellet stove is coated by high temperature resistant paint, but not against corrosion. In case of accumulation of dust, surfaces
can be cleaned with a soft brush or a dry cloth, but in any case, not with a damp cloth or water.
Upon initial ignition do not place any objects on the pellet stove and do not touch the outer surface to avoid damaging the
coating. The flavour, which is obtained as a result of the drying of the paint, disappears after a few hours. Ventilate the room
where is located the pellet stove.
If as a result of overheating or due to incorrect operation colour changes, appeared stain rust or damaged part of the coverage,
it is not a problem. You can order spray paint to your dealer.
Before ignition, check: power, door seal, if the combustion chamber is cleaned and whether the display is switched to
standby mode.
10.2.
Control panel description
.
After start up, on the control display is shown the logo of Victoria-05 for 3 seconds and then switches to main user panel. The
icons and functions are shown as follows:
Picture.4.