Vicovation Vico Power-Plus, Instruction Manual, Page: 23 / 59

English
21
Hour Setting determines the time-out schedule while you switch into Timer
Mode. Power-PLUS will cut off power output based on countdown from engine
off.
Default setting is 6 hours, and if you select the mode switch into Timer Mode,
Power-PLUS will cut off power output after 6 hours of engine-off (ACC off),
OR Car Battery voltage reach the cut-off threshold, OR environment
temperature exceed setup value.
You may select 2/6/12/24/48/72 hours.
Power-PLUS display shows up “TIME” for indicating power output cut-off
based on timer countdown finished.
Special Notcie & Self-Checking:
Make sure your low voltage threshold value suits your car battery status,
otherwise Dash Cam (Car DVR) might keep rebooting (when car-parking) due
to Power-PLUS error behavior by wrong setup.
Please make self-checking after Power-PLUS installed, to make Power-PLUS
working together with Dash Cam (Car DVR). Make sure engine off for
5~10mins without alternator affected.
Stay for a while during parking (ACC off) to see if Dash Cam operating
normally or not (Power-PLUS detects and cut off power after 30 seconds low
voltage happened). Once you found your Dash Cam keep rebooting during
parking (ACC off), you may check your low voltage setting. It may setup
too-high threshold, and you can lower down the setup value for modification.
If rebooting keeps happen, please go to professional battery diagnosis for
checking your car battery health status (CA/CCA), to check if car battery
needs to be replaced or not.
Hour Setting
Autogoods “130”
130.com.ua