Vicovation Vico Power-Plus, Instruction Manual, Page: 22 / 59

English
20
Voltage setting determines the low voltage value of cut-off threshold.
Default setting is 12.0V DC. If Car battery goes lower than 12.0V,
Power-PLUS will cut off power output to Dash Cam (Car DVR) to prevent
Car Battery from being drained out (discharged).
You may setup the threshold based on car battery status. Setup values
include: 11.4/11.6/11.8/12.0(default)/12.2/12.4/12.6V.
Under battery mode, when voltage lower than threshold longer than 30
seconds, Power-PLUS will cut off power output.
How to setup Low Voltage value fits my car?
Please use Multimeter to check your car battery voltage while engine-off
without Dash Cam loaded first (engine off for 5~10mins, without car
alternator affected).
And then, measure the second voltage with Dash Cam working-loaded
while engine-off (you may connect Dash Cam to Cigar Charger).
For example, Multimeter detects 12.5V in car battery without Dash Cam
loaded. And check again with Dash Cam loaded (plug into Cigar Charger
with ACC ON, but engine stays OFF), Multimeter may detects 12.2V
when Dash Cam loaded (working/recording). So you may setup your Low
Voltage setting in 12.0~11.8V. At least 0.2V lower than DashCam-loaded
voltage measured is needed.
Power-PLUS has Multi-input type, including DC12V and DC24V.
Power-PLUS will auto-detect your car voltage to display different
programmable setup value automatically. If your car is DC24V type, setup
value will be 23.6/23.8/24/24.2(default)/24.4/24.6V.
Low Voltage Protection works in both Normal and Timer Mode, while Main
Switch turns on (Activate) with ACC off when car parking.
Power-PLUS display shows up “LoVT” for indicating power output disable
based on low voltage happening.
Voltage Setting(Low Voltage
Cut-off Setting)
Autogoods “130”
130.com.ua