VICOR PI3741-0x-EVAL1, User Manual

Page: 6 / 9

UG:305 Page 6
Figure 7
Schematic of edge connector
PAD Definitions
Schematic Symbol
Table 3
PAD Definitions
PAD Name Descirption
P1,P2 PGND Power ground connection for the input supply and output load
P3 VOUT Output voltage connection
P4 VIN Input voltage connection
1, 2, 6, 7, 8, 10 SGND Signal ground used as reference for I/O measurements
11, 12 PGND Power ground used as reference for input and output voltage measurements
3 ENABLE Enable
4 SDA Factory use only
5 SCL Factory use only
9 ADR1 Factory use only
13 DAC External voltage node to adjust regulated output voltage (EXT_VREF)
14 EAO Error amplifier output
15 VDIFF Differential amplifier output
16 VSN Differential amplifier inverting input
17 VPN Differential amplifier non‑inverting input
18 SYNCO Sync output pin
19 SYNCI Sync input pin
20 PGD Power good status pin
21 ADR0 Factory use only
22 VDR Internal generated 5.1V supply for gate drivers and internal logic
23 ISN Remote‑sensed output voltage, after the IMON resistor
24 VIN Input supply voltage measured at SiP’s input