Vicon RV 4116, Operation And Maintenance Manual

Page: 73 / 192

4
83-004-0.
fm
ID
M
English
- 67 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ General information about the machine
Part 2
CHECK OF BELT ALIGNMENT
54
Follow the instructions.
1. Make sure tractor PTO is dis-
engaged.
2. Stop the engine, apply the
parking brake and disengage
the ignition key.
3. Check that a finished bale is to
be found inside the machine.
4. Unscrew the screws to disas-
semble the guard (A) .
5. Check if the wearing condition of
the divisions (B) is uniform on
both sides. If the divisions are
worn more on one compared to
the other side, you have to
align the belts (See "How to
adjust belt alignment").
6. Assemble the guard (A) , and
then fasten it by using the
screws.
CHANGE OF REDUCTION GEAR OIL
55
Follow the instructions.
1. Make sure tractor PTO is dis-
engaged.
2. Stop the engine, apply the
parking brake and disengage
the ignition key.
3. Prepare a container with suita-
ble capacity.
4. Unscrew the filling cap (A) .
5. Unscrew the drain plug (B) and
drain the oil in the container
completely.
6. Screw the drain plug (B) back
on.
7. Unscrew the plug (C) .
8. Pour the new oil through the fill-
ing plug (A) .
9. Stop pouring the oil before it
starts leaking from the plug
hole
(C) .
10. Screw again the plug (C) .
11. Retighten the filler plug (A) and check for leaks.
Caution
Precaution
Use oils whose features are similar to the ones that are specified in
the "Lubricant table".
Important
Do not throw away any polluting material in the environment. Carry
out their disposal in compliance with the relevant legislation in
force.
IDM-21722104000.pdf
B
A
ID
M-217221
0
4100.
p
df
A
B
C