Vicon RV 4116, Operation And Maintenance Manual

Page: 47 / 192

4
83-004-0.
fm
ID
M
English
- 41 -
▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ General information about the machine
Part 2
Loading of the machine by using
a hook-type lifting device
Follow the instructions.
1. Visually control that the locking
hooks of the tail gate are com-
pletely and correctly closed.
2. Prearrange a hook-type lifting
device with suitable capacity,
and then connect it to the ma-
chine by means of the specific
ropes (see figure).
3. Slowly lift the machine, and
then handle it with extreme
care to prevent dangerous
swinging.
4. Suitably fasten the machine to
the means of transport by means of ropes and chocks.
MACHINE-TRACTOR COMBINATION
34
–
When receiving the machine, you must check the relevant category
and the features of the tractor to which it must be coupled, so that you
can assure its stability and correct operation.
–
After having checked the features of the tractor, you must adapt the
height of the drawbar and the length of the cardan shaft (See "How
to set the height of the drawbar" - "How to set the length of the cardan
shaft").
–
The length of the cardan shaft supplied with the machine meets any
type of machine-tractor combination. The operator has the duty to cut
the cardan shaft in a correct way.
The cardan shaft must be long enough so that it does not jam
at its minimum extension or slip out at maximum extension.
Important
The cardan shaft must be equipped with a constant-velocity joint.
Consult the manufacturer's manual for further details concerning
the cardan shaft.
4,7 m
1,7 m
1,7 m
ID
M
-2172210140
0.
pdf