Accessory Kit
There is an accessory kit included with the Roughneck V920D. The table below lists the contents.
Description
Quantity
Torx wrench (to remove tamperproof screws)
1
Pipe sealant tape (to seal pipe fitting to housing)
1
Screws, anchors and rubber washers (for some
appropriate installations)
4 of each
Vent plug (for outdoor installations)
1
Terminal blocks, 3-pin (24 VAC power); 4-pin (alarm
output); 2-pin (RS-485)
1, 1, 2
Cable access plug (black; for rear hole)
1
Cable access plug and tool (threaded; for side hole)
1 of each
Grommet (for routing cable; rear access)
1
Mounting the Unit
Select a location for the installation of the V920D camera. Be sure the area around the selected location is
clear of obstacles (such as steel beams, headers, pipes, electrical wiring, etc.) which would interfere with the
mounting of the camera and that the location can support the weight of the unit [the V920D unit weighs 2.5 lb
(1.1 kg)]. Video and power cables must be routed to the installation location.
The V920D mounts directly to a ceiling or wall. The base has four mounting holes; two cable access holes are
provided. As a mounting alternative, the mounting holes align with a standard 4 x 4 electrical box for mounting; an
adapter plate is available that creates an aesthetically pleasing appearance (model V920D-PLATE). Refer to
Mounting Hole Figure that follows. To mount the V920D, follow the steps below.
1. Loosen the four (4) Torx screws securing the cover; leave the screws intact. The cover is attached to the
base by the safety cord upon delivery. Allow the cover to hang.
10 Installation
Torx screws
M5x10 (4x)
Caution:
Do not attach these units to drywall surfaces and do not install mounting screws into the end
grain of wood.
