50
Preparing for use
OptiCut 14 and
OptiCut 23
SuperSilage
Removing the knives
The knife driving shaft can be accessed via the bale chamber. Please
observe the relevant safety instructions »Working in the bale cham-
ber«, page 49.
Switch on the AutoPlus-Pilotbox.
> Press the “ON/OFF” button.
> Press the “INFO” button...
> ...until the “Pick-up/Knives” symbol is displayed.
> Press the “GO” button...
> until the “Pick-up/Knives” symbol is selected on the display.
> Swivel the knives in via the control device.
> Open and secure the rear flap.
→
»Opening the rear flap«, page 46.
> Close the ball valve for the cutterbar (to do this, open the right-hand
side door).
> Release the knife driving shaft locking mechanism.
> Pull the knife driving shaft lever downwards.
> Hold the ends of the knives and pull them out of the knife driving
shaft towards the rear.
N
OTE
The cutting knives must always be well sharpened. Sharp knives save
energy and guarantee the highest possible quality.
→
»Sharpening the knives«, page 98
Cutterbar ball valve
Lever for the
knife driving
shaft
Locking mecha-
nism
Lever for the
knife driving shaft
Summary of Contents for RF 2235
Page 5: ...Inhaltsverzeichnis 5...
