XX185-30 Rev 807 Kollector Lite
Configuring the ViconNet System
•
149
7. Select the required
Video
settings for the alarm-activated recorded data, as follows:
•
Quality:
The picture quality that you select determines the resolution at which the pre alarm and/or
post alarm data is recorded.
Select the required picture quality from the range of one to eight, where:
•
1
= best picture quality, but slowest data transmission.
•
8
= least clear picture quality, but fastest data transmission.
•
FPS:
The rate at which the pre alarm and/or post alarm data will be recorded.
Select the required frames per second from the available range (NTSC: 1 to 30; PAL: 1-25).
Refer to
Chapter 2, Getting to Know ViconNet
, for additional details about picture quality and FPS.
8. Select one of the following
Mode
settings (refresh mode):
•
Normal:
Records only changes within the frames for pre and post alarm data.
•
Full:
Records full frames for pre and post alarm data.
Refer to
Chapter 2, Getting to Know ViconNet
, for additional details about the refresh mode.
9. Click
to save your settings and close the
Pre/Post Alarm Settings
window.
Creating Schedules
A schedule is a group of user-defined settings that cause the system to activate a selected macro during a
specific time period and for a specific length of time.
The ViconNet system enables you to use the ViconNet application to create multiple schedules, according
to your requirements, which consists of selecting which macro to run on which days of the week, as well as
a start time and end time for each day.
Each schedule, using its defined macro, performs the respective commands on the configured camera
inputs only during the time periods defined in the schedule. The transmitter remains idle during the
non-scheduled times.
During schedule configuration, you can also determine if the defined macro will run continuously during the
selected time period or at specific intervals. This enables you to fine-tune your macro operations and may
reduce storage space in the storage location by recording data only during the scheduled time periods. You
can also modify or delete an existing schedule, if required.
To create a schedule:
1. Ensure that you have created the required macros, as described in
Creating Macros
, page 108.
2. From the ViconNet
Main
window, click
. The
Setup Site Selection
window is displayed, as
shown on page 57.