Parking and storage
41
Parking and storage
Safely setting
down the
implement
When setting down and parking the implement special safety precau-
tions have to be observed:
Observe safety instructions
Do not fail to observe the safety instructions when performing all work.
Any disregard for safety instructions can lead to serious or fatal inju-
ries to persons.
The implement is not a toy
Never allow children to play on or around the implement. Metal edges
and work tools of the implement can cause serious injury.
General
Uncouple the implement in the reverse order to coupling.
Chapter »Coupling the implement«, sections »Coupling the pending at-
tachment« and »Coupling the lift link drawbar« page 22
Uncoupling and
securing the
implement
To uncouple the implement from the tractor proceed as follows:
•
Stop the implement on firm, level ground in the transport position.
•
Secure the tractor against rolling away, switch off and take out the
ignition key.
•
Secure the implement against rolling away by using wheel wedges.
•
Pull off the cardan shaft and place it on the holder provided.
•
Close the ball valve and release the hydraulic couplings.
•
Insert the hydraulic couplings into the parking pockets on the im-
plement.
•
Disconnect the lighting plug and insert it into the parking pockets
on the implement.
•
Lower and secure the sustainer.
•
Coil the electrical cables.
•
Unhitch the implement.
After the end of
the season
After the end of the season and if the implement is to be stored for a
long period of time, perform the following work:
> Clean the implement thoroughly.
> Check all the screw joints and tighten the screws.
> Repair or replace any damaged components.
> Repair any paint damage.
> Lubricate the implement in accordance with the lubrication sched-
ule.
> Check the tyre pressure.
