Additional equipment
61
Fitting the chassis on machines with night swath equipment
Using a pipe clamp, fasten the gaiter on the profile shaft of the rotor
chassis.
Use a floor conveyor to align the rotor chassis at a right angle
under the rotor gear, and slowly lift until the spindle for the working
depth sits on the profile shaft of the rotor gear.
Carefully place the spindle on the rotor gear onto the rotor chassis,
and screw it into the profile shaft of the rotor chassis using at least
5 turns.
Fit the adjusting screw for lifting the tines.
Fit the self-locking nut from the rear to prevent the spindle turning
out. The gap between the self-locking nut and the hexagonal pro-
file is around 5 mm.
Switch on the tractor.
Use the tractor's hydraulic control device to completely fold back
the lift arms.
Switch off the tractor and secure it.
Close the ball valve.
M16 lock nut
Gaiter
Pipe clamp
Profile shaft
Spindle
Pipe clamp
Gaiter