Preparations on the field
56
Single swath
In single swath mode, the rear rotor is swivelled to the left. By slewing
the front rotor the following positions are possible:
•
Fodder slow gear
•
Border swaths.
Adjusting the single
swath
Fold the machine into its work position.
Switch off the tractor and secure it.
Switch off the pilotbox.
Remove the ignition key.
Check that the rear swath former is fitted to the front hole pattern.
Additional swath former
Remove it from the front rotor.
Push it into the transport holder from the right and secure in
place.
Move the selection lever to the single swath position and lock in
place.
Select position A on the pilotbox.
Drive slowly forwards and swivel the rotor to the left using the
tractor's hydraulic control device. The steering cylinder is fully
retracted.
If necessary, briefly extend the steering cylinder before the automatic
preselector is released and travel can proceed in the straight-ahead
position.
Support the retraction of the pivoting cylinder by slowly driving
forwards.
The rear rotor can be slewed with this setting on the preselection level
only to the left and back to the middle. To swivel to the right to the two
single swaths setting, you have to move the selection lever.
Single swaths
Collision danger
Check that the rear swath former is fitted into the front hole pattern
on the swath former carrier. The additional swath former on the
front rotor must be removed, pushed into the transport holder from
the right, and secured. Otherwise, there is a risk of collision and
damage to the machine may be caused as a result.
Summary of Contents for Andex 714 T Vario
Page 4: ...Table of contents 4 ...
