16
|
ViconNet Nucleus Installation and Configuration Guide
Step 1: Setting the Site’s IP Address
In this step, you will configure the IP address of this site in the network.
1. Go to the site whose IP address you want to set. Then, from the ViconNet
Main
window, click . The
Setup Site Selection
window is
displayed, showing a list of all currently connected transmitters and
Workstations.
2. Select the site name for which you want to configure the network setup and
click . The
System Settings
window is displayed, as previously
shown.
3. Click
. The
Network Settings
window is displayed.
4. You can change the device's name, if required, by clicking
to
open the
Change Name
window. After you have assigned a new name to the
site, click . The system will reboot.
5. (Optional) To manually synchronize the local device time with all sites
connected to it (the Nucleus), select the
Synchronize Time on the Network
option (default=checked).
Note
The system also automatically synchronizes the time every one minute.