•
Select
Settings → COM Ports
In the COM ports screen, use the keypad to change the communication module configuration to RS/485 Half
Duplex, or RS/422 Full Duplex.
3.4.15 Select the Network or Standalone mode
•
Select
Settings → Mode
Define in which mode the ZPU-5000 will operate. by pressing
ENTER
. The unit must be restarted after
selecting the desired mode.
•
Select
Connected to the ZOOM system
when the ZPU-5000 is connected to a network and is
managed through the ZOOM software.
•
Select
Standalone, not connected to ZOOM
when the ZPU-5000 is not connected to a server.
3.4.16 Create access codes and attribute access rights
By default, the ZPU-5000 acquisition unit offers unrestricted access to any command on the menu. If you need
to restrict access to some command sequences, use the Create Access Code command. After access codes
are created, only users with an access code and an Admin access right have unrestricted access.
The following table shows which operations (sequences of commands) are accessible to users according to
their access right, when access is controlled by an access code:
Operation
Admin
Guest
Configuration → Import
Yes
Configuration → Export
Yes
Yes
Information → About VibroSystM
Yes
Yes
Information → System
Yes
Yes
Information → Modules
Yes
Information → Alarms
Yes
Information → System OK Detail
Yes
Settings → Display
Yes
Yes
Settings→ Address
Yes
Settings → COM Ports
Yes
38
ZPU-5000 Acquisition and Processing Unit with ZOOM Version 7.4 - User’s Manual
