3.4.10 Adjust the front panel brightness
•
Select
Settings → Display → Brightness
This screen provides a way to change the brightness level.
3.4.11 Change the power saving option
•
Select
Settings → Display → Power Options
This menu allows setting a delay after which the front panel display turns off automatically to save power.
By default, the display is always powered on. Use the left or right arrow to change the setting from Never to a
maximum delay of 25 minutes.
Once the display has turned off, you can turn it back on by pressing on any key.
3.4.12 Attribute a unit address
Important Information
•
The unit must be rebooted after changing these parameters.
•
Select
Settings → Address
Select the Address option to assign an address for the ZPU-5000 unit
Use the right or left arrow key to position the pointer, and use the up or down arrow key to change the selected
character.
3.4.13 Change the IP address protocol (enable or disable DHCP)
Select the IP address option to enable or disable Dynamic Host Configuration Protocol (DHCP).
By default, DHCP is enabled.
When DHCP is disabled (set to No), three additional parameters appear:
•
Static IP address
•
Subnet Mask
•
Default Gateway
These additional parameters can be edited with the keypad. For more information regarding DHCP, please
contact your network administrator.
3.4.14 View or edit communication port settings
Important Information
•
On newer units (9183-06G00-21x and up), the
COM ports
option does not open, even if a plug-in is
installed. No modifications can be made from the ZPU-5000.
•
On older units (9183-06G00-20x), the COM ports option opens, allowing the user to modify the
configuration.
ZPU-5000 Acquisition and Processing Unit with ZOOM Version 7.4 - User’s Manual
37
