Chapter 1
Xgig1000 System Overview
Xgig1000 2 Port 10G/40G Chassis
Page 42
Xgig1000 Hardware Guide
March 2017
Figure 6
Cabling the 40G QSFP Ports For Use As 10G SFP Ports
Front Panel Reset Button
To safely shutdown the operating system and power off the chassis, press and hold the
Front Panel Reset
button for two seconds until the System LED starts blinking yellow.
Stop pressing the button as soon as you see the System LED blink. This will allow the
system to do a graceful shutdown.
•
For Xgig 1000 units with the original motherboard
(no rear power switch on the
back panel), the System LED will become steady yellow when the system has shut-
down. This is the indication that you can remove the power cable.
•
For Xgig 1000 units with the new motherboard
(rear power switch on back panel),
all LEDs will go dark and the motherboard will show no power when the system has
completed the shutdown. At this point the power to both the protocol board and the
motherboard has been removed. The only power going into the chassis at that point
is into the Power Supply. This is the indication that you can switch the power switch
to the off position.
If you press and hold the
Front Panel Reset
button down for six seconds or longer, it
forces an abrupt termination and a graceful shutdown may not have completed.
