Viavi T-BERD 6000A V2, User Manual

Page: 33 / 188

Chapter 3 Starting up
Choosing the position of the instrument on the work surface
User Manual 76100000200 Rev. 001 13
Removing a
plug-in
1 Unscrew the two captive fixing screws of the plug-in completely (up
to the stop).
2 Carefully slide the plug-in out of its slot.
Choosing the position of the instrument on the work surface
Depending on the conditions of use of the 6000A V2 Platform, the instru-
ment may be placed on a flat surface or held in the hand.
When used on a work surface, the 6000A V2 Platform should be
supported on its stay, which can be set in either of two positions,
depending on whether the user is standing or sitting.
To change the stay from “seated user” position to “standing user” posi-
tion, press both sides to slide the stay towards the upper end of its
groove, as shown in the drawings below.
The stay is available exclusively on the Single FO Module carrier
(reference E6100).
Fig. 6 Stay in positions for seated user and standing user
Seated user
Standing user
(recommended)