Viavi SmartOTDR 100, User Manual, Page: 140 / 156

Chapter 11 Maintenance and Troubleshooting
Maintenance procedure
122 User Manual 7SMART102 Rev002
Checking new
upgrade on Viavi
Server
If the Viavi Server is selected for upgrade (see Figure 82 on page 118 ),
the parameter Check new release can be defined to automatically
inform user of a new upgrade available for Platform.
1 In the System Settings screen, select Connectivity > Upgrade
icons.
2 Check the Address Type is set to Viavi Server .
3 Define the parameter Check new release to Enable .
If the parameter is set to Enable , a message displays, at any time,
when one update is available on server.
4 Press Ok to display the list of software versions available (see
Figure 83 on page 119 ) and follow instructions “Launching the
upgrade” on page 121 .
Upgrading from
the boot
This method is used to make a complete reinstallation of the software
versions.
1 Turn off the SmartOTDR using the
O
N
/O
FF
button, keeping the
equipment connected to the mains.
2 Insert the USB stick onto which the software versions are stored into
one of the USB port of the Platform
3 Press simultaneously S
ETUP
+ S
TART
/S
TOP
buttons
4 Maintaining the two buttons pressed, press O
N
button to start the
SmartOTDR.
5 A menu displays, then the screen allows to select Upgrade from
USB
After a few seconds, a new page displays indicating that to continue
the reboot, the validation key must be pressed.
Press the hard key
.
Fig. 85 Checking new release