Viavi Seeker X, User Manual

Page: 47 / 66

Seeker X User’s Guide
22137808, Rev. 001 Feb 2020 47
Chapter 2 Using Your Seeker X
SEEKER X
μV
m
dB
NOISE
FREQ PK DIST GPS
Adjusting the speaker volume
To check the volume of the leakage tones, press the
VOLUME
button. The speaker icon displays.
y
Press VOLUME again to adjust the level. There is no sound
for the adjustment, the bar graph shows the level instead,
as shown here.
When leaks are found, you will hear the volume change in
the leakage tone.
y
The display continues to show the RF signal level as you
adjust.
y
You can also press and hold the volume button to quickly increase the volume and
lower it again.
Speaker volume level
While testing for leaks, you may need to adjust the volume of the leakage tone.
NOTE:
The display will revert to the signal level display after a few
seconds in the speaker volume level display (without any
action by the user).
Speaker volume
SEEKER X
μV
m
dB
NOISE
FREQ PK DIST GPS
Use the VOLUME button to adjust the
volume. The bar graph at the bottom
will show the level.