manualshive.com logo in svg

Viavi OSA-4100, Quick Card User Manual, Page: 4 / 4

Share
Download
Viavi OSA-4100 Quick Card User Manual Download Page 4

VIAVI//Public

T-BERD/MTS 2000 Handheld Modular Test Set

T-BERD/MTS-2000 Handheld Modular Test Set

Q U I C K   C A R D

© 2021 VIAVI Solutions, Inc,
Product specifications and descriptions in this 
document are subject to change without notice.
Patented as described at viavisolutions.com/patents

Contact Us

To reach the VIAVI office nearest you, 

visit viavisolutions.com/contact

+1 844 GO VIAVI

(+1 844 468-4284)

R U N   S W E E P   T E S T

3.

Tap

START 

icon (upper right) to run scan

4.

View Results after scan completes (use your finger or stylus to scroll up/down as needed)

Total # of 
Channels 

detected

Verifies Channels &

Power Levels (dBm)

Measures offset

(detect optics going bad)

Measures

Actual 

wavelengths

Summary of Contents for OSA-4100

Page 1: ...ection test Repeat until it passes 4100 series Nano OSA This quick card describes how to connect to a fiber under test configure test setups run tests and analyze results with a T BERD MTS 2000 equipped with a Nano OSA module EQUIPMENT REQUIREMENTS FIBER INSPECTION GUIDELINES T BERD MTS 2000 equipped with the following Fiber Optics Software Release V21 14 or greater Nano OSA Module OCV 4100 or OSA...

Page 2: ... coupler during turn up or maintenance 1 Inspect the Nano OSA port on top of the test set 2 If connecting to the Common Cable connect the Common Cable to an optical coupler with the same connector type and inspect the fiber end face in the coupler 3 If connecting to the Monitor Port or Common Port on the Mux inspect the Mux Port 4 Inspect the fiber end face of the Patch Cable and connect the cable...

Page 3: ...tton to display the Home view with the Optical Spectrum icon 3 Tap the Optical Spectrum icon until it is yellow and highlighted Figure 6 Home Screen 1 Tap Setup icon 2 Tap each setup category and verify they match as shown below Note The below shows the default setup for standard use of the Nano OSA User typically does not need to change any settings for running a sweep of channels Figure 7 Setup ...

Page 4: ...ted as described at viavisolutions com patents Contact Us To reach the VIAVI office nearest you visit viavisolutions com contact 1 844 GO VIAVI 1 844 468 4284 RUN SWEEP TEST 3 Tap START icon upper right to run scan 4 View Results after scan completes use your finger or stylus to scroll up down as needed Total of Channels detected Verifies Channels Power Levels dBm Measures offset detect optics goi...

Reviews:

No comments