Viavi ONX-220, User Manual

Page: 117 / 212

ONX-220 User's Guide
22135173, Rev. 000 June 2020 117
Chapter 9 Configuring the OneExpert with StrataSync
Three locations are currently available for different limits to be set:
y
Tap
y
Ground block
y
CPE location
For each item, a value can be entered that corresponds to the limits of that
measurement at that location.
The type of limit is also selectable:
y
Error – Pass if results meet the limit requirements or fail if results exceed limits.
y
Warning – Pass but no fail; the measurement is highlighted to bring attention to
the result that has exceeded the limit.
y
None – Test result is shown but no pass or fail criteria is applied to the result.
Viewing, Editing, Renaming, or Deleting a Limit Plan
1. Check the box in front of the desired limit plan.
2. Select the
Action button above the left side of the list
pane. The Actions dropdown appears.
3. Select View, Edit, Rename, or Delete from the
dropdown list and change or confirm from the
following screen.
For deployment, see Limit Plan Deployment in the next
section.
Saving Limit Plans
When all values have been entered, select Save .