Chapter 2
Setting up the system
Setting up the Job Manager
ONA-800 Getting Started Guide
Page 20
22142812, D1 R004
August 2020
1
Ensure that the unit will have an uninterrupted supply of power during the update.
If necessary, connect the AC power adapter to the unit.
2
Select
System
on the menu bar, select
Upgrade
, and then select
Network
.
3
Do one of the following:
a
Enter the server address where the update is located.
b
Enter the address where the software file is located; for example, the FTP
address, server IP address or host name, and the proxy server address (if
necessary), as well as the access credentials.
4
Select
Connect
.
5
After the unit accesses the server, select the link for the software file for the unit.
Note the following symbols that may appear beside the release number of the
software file:
–
An equals symbol indicates that the software on the USB stick and the
software on installed on the unit are the same (that is, have the same release
number).
–
A down-arrow symbol indicates that the software on the USB stick is an
earlier release than the software installed on the unit.
–
An up-arrow symbol indicates that the software on the USB stick is a later
release than the software installed on the unit and the system software can
be upgraded to the later release.
6
Select
Start Upgrade
.
A dialog box appears with prompts to either exit all tests that are running or cancel
the update if the tests cannot be stopped.
7
Select
OK
to begin the software update.
The unit automatically restarts when the update is completed.
Setting up the Job Manager
Test Process Automation (TPA) supported via the Job Manager Icon includes Techni
-
cian Guidance. A step-by-step walk through of the testing tasks associated with the job
includes being able to launch the job or to review a job guide for the specific task. After
all tasks are completed the technician will be notified and prompted to return to the Job
Manager.
WARNING:
Electrical shock may result in serious injury or death. Be sure the AC power
adapter is connected to the correct voltage mains. Do not use the adapter
outdoors or in wet locations. Use only the AC power adapter supplied with
the unit.
NOTE
The software update can take several minutes, depending on the speed and reliability
of the network.
