FVAi-2030 Benchtop Microscope User Guide, 22112369-339 R000, Standard
4-2
Using the FVAi-2030 microscope with FiberChekPRO
Connecting to FiberChekPRO
Connecting to FiberChekPRO
You can use the FVAi-2030 microscope with the FiberChekPRO inspection software via a USB connection to the
computer where the software is installed (see
). You can then perform Pass/Fail tests, view
test results, generate fiber inspection reports, and manage inspection and microscope settings.
You can also update the microscope firmware or perform a system reset when required. For information, see
Step 1 Start FiberChekPRO.
Step 2 Connect a USB cable to the USB interface on the microscope (see
) and then to
the computer.
Step 3 Power on the microscope (see
“Powering the FVAi-2030 microscope on or off” on page 2-3
).
The LCD touchscreen on the microscope initializes, and FiberChekPRO automatically detects the
microscope.
Note:
While the microscope is connected to the FiberChekPRO inspection software, you can toggle the
output mode so that you can use either the software or the LCD touchscreen. Select the
Home
tile on the touchscreen, access the
Home Screen
menu, and then select
OUTPUT LOCAL
on the
Inspection Settings
“Navigating the Home screen” on page 2-6
— End —
