Chapter 2
Getting Started: Setup and Operation
Powering the Test Set
Rev. 001
CX300 ComXpert Operation Manual
22130634
2 - 6
February, 2022
To Charge the Battery
1.
Connect the test set to an AC power supply. See
2.
Verify the test set Power button LED flashes amber to indicate the batteries are
charging.
3.
The
Power
button
LED turns on and stays green when the batteries are fully
charged.
2.2.3 Turning the Test Set On
The CX300 is powered on and off using the
Power button
located on the top panel.
To Turn ON the Test Set
1.
Press and hold the
Power
button
for approximately 1 second, then release.
2.
Verify the
Power
button
LED
illuminates. The
Power
button
LED
color
"POWER BUTTON/LED" on page 1-9
for detailed
information).
3.
An initializing indicator screen is displayed during the boot-up process.
4.
The last viewed screen is displayed when the test set is ready for use.
2.2.4 Turning Off or Rebooting the Test Set
The following procedures describe how to turn off or reboot the test set when
controlling it remotely:
5.
Navigate to
Home
.
6.
Press CTRL + Q.
7.
Select either
Power off
or
Reboot
, as desired.
The following procedures describe how to Turn OFF the Test Set:
1.
Press and hold the
Power
button for approximately 1 second, then release.
2.
When prompted, select
Power off
from the
Power Options screen
to power
down the test set.
3.
Wait while the test set performs a series of reboot processes. Do not interrupt
the power-down process or unsaved information may be lost.
NOTE
An initializing indicator screen is displayed during the boot process which can take
~ 5-6 minutes.