CPRIAdvisor Installation Guide
37
Procedure
1
Click
button on the
Probe Connection Management
pane.
2
Insert the assigned IP address in a pop-up window.
3
Click
button at the bottom of the
Probe Connection Management
pane.
4
Once connected, the Probe appears as highlighted in purple.
NOTE
If you failed to connect to the Probe, make sure to check your LAN cable is properly
connected to Probe and PC. If you have more than 2 adapters, make sure to check
your network adapter connected to the Probe is the same as the one appeared in the
Communication
from the menu bar.
Setting up CAP-100 via CAM-100
To view an accurate monitoring result, you need to set up your CAP-100 with specific values based
on your installation environment. Below is an example of the setup.
Initializing your CAP-100
Procedure
1
Click the
appeared on the
Probe Information Management
