Viavi Certifier Series, User Manual, Page: 19 / 25

4
Chapter 4: Configuring an AUTOTEST
After configuring the system settings, follow these steps to set up an autotest.
1. Press the SETUP button > Project Settings
a. Site
– Create or select a Site
b. Operator
– Create or select an Operator
c. Label Source
– Select cable labelling scheme. Load labels from USB
flash drive if using List Based Testing (LBT).
d. AutoSave
– Enable option for Certifier to auto save every PASS result.
2. Press the SETUP button > Test Settings
a.
Test Limit
– Select a test limit
TX TX TX TX TX TX TX TX
40Gbase-SR4
TX TX TX TX TX TX TX TX TX TX
RX RX RX RX RX RX RX RX RX RX
100Gbase-SR10
b.
Channel Selector
– Select Channel(s) of cable where loss limit will be
applied
c.
Cable
–Select “Generic”
d.
Connector
– Select “Generic”
Please ensure you have the following components before conducting the test;

Certifier, Local & Remote units

MPO Testing Kit
Please ensure you have the following components before conducting the test;

Certifier, Local & Remote units

MPO Testing Kit