Viavi CellAdvisor 5G, User Manual

Page: 320 / 359

5G TM Signal Analyzer
308
If you select the operating frequency as FR1 , select from the following:
▪
SCS 15 kHz: 5, 10, 15, 20, 25, 30, 40, 50 MHz
▪
SCS 30 kHz: 5, 10, 15, 20, 25, 30, 40, 50, 60, 70, 80, 90, 100 MHz
▪
SCS 60 kHz: 10, 15, 20, 25, 30, 40, 50, 60, 70, 80, 90, 100 MHz
▪
Tap Duplex Type between FDD and TDD required.
- FDD : both uplink and downlink can transmit at the same time at different spectrum frequencies
- TDD : both uplink and downlink use the same spectrum frequencies but at different times
If you select the operating frequency as FR2 , select from the following:
▪
SCS 60, 120 kHz: 50, 100 MHz
▪
You can only select the Duplex Type as TDD .
3 Based on the above setting, tap Test Model FR1 and select the options from the following choices: FR1-TM1.1, FR1-TM1.2,
FR1-TM3.1, FR1-TM3.1a, FR1-TM3.2, FR1-TM3.
4 Based on the above setting, tap Test Model FR2 and select the options from the following choices: FR2-TM1.1, FR2-TM2, FR2-
TM3.1.
5 Tap SEM Config to configure the following items:
a Tap BS Type and select the option from 1-C/1-H , 1-O , or 2-O .
Set 1-C (Conducted)/1-H (Hybrid) for multi-band operation with mapping of transceivers to one or more antenna
connectors (1-C) or TAB (transceiver array boundary) connectors for 1-H. Set 1-O when BS operates at FR1 and 2-0
when BS operates at FR2.
b Tap Category and select the option from Wide Area BS A , Wide Area BS B , Medium Range BS , or Local Area BS .
The category is defined with base station type. Set Wide Area BS A/B for macro cell, Medium Range BS for micro cell,
and Local Area Base Station for pico cell.
c Tap Mask Type and select the option from KCA or 3GPP .
You can select the KCA to follow Korea Communications Agency standard (Korea-specific) or select 3GPP to follow
international standard.
6 Tap Menu > BW/AVG > Average to set the number of measurements to be averaged using the on-screen keyboard.
The input value range is from 1 to 100.
Setting limit
1
Tap the Menu > Limit on the side bar.
2 Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indication.
The result table color for Pass is green, and the result table color for Fail is red.
3 Optional . Tap the Save icon on the side bar and select the save option form the choices available for your measurement mode.