ViaSat VMBR-1520, Installation, Operation And Maintenance Manual, Page: 40 / 88

VMBR-1520 Mobile Broadband Router Installation, Operation, and Maintenance Guide
Initial Set Up and Configuration
1075152 Rev. 001
3-6
3.3.2.3 Ping the Hub Test Server
On the PC or laptop, open a command prompt, and enter
ping a.b.c.d –t
where a.b.c.d is the IP address of the hub test server,
i.e.
ping 204.14.40.60 –t
. The command prompt window should
display echo replies as shown in Figure 3-3. Press CTRL-C to cancel the
ping command. The ping echo verifies the modem connectivity.
Figure 3-3. Ping the Hub Test Server
√ After successfully completing the above steps, initial the table in
Appendix B, and proceed to the next section.
Refer to Paragraph 6.6.4 for troubleshooting procedures if the modem
could not receive any ping response from the hub test server.
Note Contact the satellite
operator or service provider
for the hub test server’s IP
address.