ViaSat VMBR-1520, Installation, Operation And Maintenance Manual, Page: 38 / 88

VMBR-1520 Mobile Broadband Router Installation, Operation, and Maintenance Guide
Initial Set Up and Configuration
1075152 Rev. 001
3-4
3.3.2.1 Ping the Modem
On the PC, open a command prompt, and enter
ping a.b.c.d –t
where
a.b.c.d is the IP address of the modem, i.e.
ping 192.168.0.1 –t
. The
command prompt window should display echo replies as shown in
Figure 3-1. Press CTRL-C to cancel the ping command. The ping echo
verifies the modem’s connectivity.
Figure 3-1. Ping the VMBR-1520
√ After successfully completing the above steps, initial the table in
Appendix B, and proceed to the next section.
Refer to Paragraph 6.6.2 for troubleshooting procedures if the modem
does not respond to the ping command.
Note Make sure that the
support PC’s IP address is
configured to operate on the
same network and subnet
as the VMBR-1520.