ViaSat ArcLight, User Manual, Page: 297 / 368

ArcLight Hub User’s Guide
Component Operating Procedures
Rev. 001 1081006 5-45
It also displays a short status of the CDCs in the chassis. This
command takes one argument - verbosity:
•
0 - outputs the configurations of M&C, UC, and configuration
and short status of active CDCs only. This is the default
verbosity when none is supplied.
•
1 - outputs the configurations of M&C and UC only.
•
2 - outputs the configurations of M&C, UC, and configuration
and status of all CDCs. Eb/No target table is not outputted.
•
3 - outputs the configurations of M&C and UC only.
Table 5-8. MCD M&C ‘sd’ or ‘sky_dump’ Command – Parameter Descriptions.
Field Description
Active LAN 1 IP address Active M&C LAN 1 IP address
Active LAN 2 IP address Active M&C LAN 2 IP address
Standby LAN 1 IP address Standby M&C LAN 1 IP address (unused)
Standby LAN 2 IP address Standby M&C LAN 2 IP address (unused)
NMS IP Address SNMP traps are sent to this NMS IP address
NMS Port SNMP traps are sent to this NMS port
RtNMS IP Address UDP Link Status packets sent to this RTNMS IP address
RtNMS Port UDP Link Status packets sent to this port number at RTNMS IP
address
RtNMS Log Port Unused
MCD Spigot 0=reassembled packets are not transmitted from chassis
3=reassembled packets are transmitted on LAN 1
Congestion Control Enabled – Enable congestion control processing
Disabled – Disable congestion control processing
Leader VCI Uplink Power Control Leader VCI
VCI Minimum Bursts with VCI below minimum are dropped
VCI Maximum Bursts with VCI above maximum are dropped
Active M&C CP Indicates Active M&C physical chassis slot number 8 or 9
Util. Card DVBN Average of DVB center frequency after N samples (unused)
Util. Card DVB Data Rate UC DVB symbol rate (unused)
Util. Card DVB CtrFreq UC DVB center frequency in Hz (unused)
Util. Card Die Timeout The time before Utility Card reboots itself if it does not get the M&C
poll (in seconds)
Util. Card Rsp Timeout The time the M&C waits for Utility Card response (in seconds)
Util. Card Poll Rate Rate at which M&C polls the Utility Card (in seconds)
Numer of CDCs detected The number of currently active CDCs (active is booted up and ready
for traffic)
St (Configuration) Chassis Logical Slot Number
H (Status) CDC FPGA health - 0=dead, 1=loading, 2=fault, 3=not yet
configured, 4=idle, 5=demodulator ready, 6=detecting bursts
SelfTest (Status) Self-test results - 80000000 = all pass, any other means
some failure has occurred
Actv (Status) M&C view state of the CDC - -9=hot swap ready, 0=off, 1=PCI
detect in progress, 2=awaiting 1
st
health response, 3=sending